The suspenders will hold the legs in place and allow them to move naturally as you walk. Staple or glue the suspenders to the front of the legs, then run the straps over the wearer's shoulders and cross the straps behind the back before stapling the straps to the back of the thigh strip (as seen in the picture). Use the nylon strapping to create suspenders. With the legs complete, step into the legs and hold them up so that they hover just over the top of the wearer's foot. Take one more strip of cardboard and glue it along the top of the inside front of the leg, attaching the two legs (see the unpainted strip in the picture - this one has ripped with repeated use but it should be whole). Now use your box cutter to remove the inner and rear "thigh" pieces, leaving a minimum 2" strip around the leg. Fold the front of the tube at the cutout creating a movable knee. Using your box cutter, cut out triangles on the sides at the knee (this will be above the wearer's knee) and a rectangle from the back. Glue each rectangle tube closed leaving the top and bottoms open. Use a large box to form 2 long rectangular tubes wide enough for your legs and small enough to fit up under the torso. In this game, Steve is holding a blasting competition and each player must work hard to try and be crowned king of the competition. DO NOT cut the eyeholes in this step, we will do it later. CrazySteve.io is an awesome multiplayer game based on the iconic Steve from Minecraft. The picture above shows the completed headbox from below, showing the headstrip. When you have adjusted the headstrip's height and fit correctly, glue the headstrip into place inside the headbox. This allows the head to move as the wearer's head moves, otherwise the wearer would not be able to see anything side to side. The head box should not rest on the costume's shoulders, it should rest on the headstrip with an inch or two clearance from the shoulders. Wearing the headstrip and the torso, place the head box on your head and adjust the size so that the head sits level and comfortable. The strip needs to sit level on the top of the head leaving a flat cardboard circle at the top without any head/hair coming out the top. Now take a strip of cardboard and wrap it around the wearer's head like a crown, approximately 4 inches tall. You can fit your head in diagonally (nose to a corner) when putting it on the wearer for more room. Cut an access hole for the wearer's head on the bottom side leaving a small border. Assemble the box and glue the flaps shut top and bottom.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |